Blue Sea Systems Fuse Block ST Blade with Ground Cover
- Provides two isolated groups of six ato/atc circuits
- For Use with either two isolated batteries or with a single Battery providing a Mix of 24 hour and switched circuits
- Tin-plated Copper buses and fuse clips
- Clear insulating cover with label recesses and storage for two fuses, satisfies abyc/USCG insulation Requirements
- Fuses sold separately
Split bus FUSE block with ground for use when a mix of switched and 24-hour circuits are desired in the same block. Tin-plated copper bases and FUSE clips. Easy to open, push button latch for easy access to fuses. Screw Terminals for securing wires accept ring Terminals. One-piece stainless flange nuts ensure safe and secure connections. Includes write one labels and one 15A FUSE.
Marine Gps Chartplotter
Kolton
April 4, 2017Great fuse block,
The connections for the fuses are all solid and hold the fuses tightly. The fuse block has a nice heft to it and has Two easily accesible spare fuse holders in the cover. I found the fuses stick out far and have adequate spacing between them to easily pull them out with out a special tool or pliers. The only complaint that I could have with it is the size of the studs and nuts on it. They’re good for smaller ring terminals but I used 4 gauge wire and the only ring terminals I can get locally are large enough to fit over the nut. This is easily remedied with a washer but it would have been nice to have one supplied with it anyways.
Overall I’m extremely satisfied with this fuse block and will purchase more in the future.
Was this review helpful to you?
Anthony Smith
April 4, 2017Love it, Gave my truck a professional aftermarket look.,
I used 8ga wire for the Positive and Negative Pus as I was only running the cables 2 feet to the battery, and for the two components I have hooked up I’m using 16ga as that is all that’s required for the amp/wire length.
If I HAD to complain about something It would be the fact that the fuse block has a 100 Amp max per block, and a 30 Amp max per circuit limitation. If you wanted to use all 12 circuits you could only use an average of 7.5amps each (technicaly just over 8 amps but the don’t make 8 amp fuses) So if your purchasing this for your jeep and have a lot oh halogen lights you want to wire up or perhaps a large boat you may run into some power constraints. Granted 100 amps is still a lot of power but It’s the only limiting factor I can think of.
Was this review helpful to you?